Does anyone know if the replacement lower screen sold here comes with the digitizer?

Meu Problema

So, my buddy brings over his beloved high-end gaming PC. "It's dead, Jim," he says. No power, no lights, no dramatic smoke, just... silence. But here's the clue: if you left it unplugged for a while, it would sometimes power on for a few seconds before dying again. It was like a shy creature that needed a long rest before mustering the energy for a brief "hello." This pointed directly to the heart of the machine: the Switch-Mode Power Supply (SMPS) .https://sieconxk.com/ .motherboard. It wasn't completely dead; it was protecting itself. The problem was likely in the primary side, probably a component failing under load.

Minha Solução

UNPLUG EVERYTHING. I can't stress this enough. Those big capacitors can hold a lethal charge for a long time. I discharged them properly using a resistor. Safety first, always!I opened up the PSU and gave the board a good look. I was looking for the usual suspects: bulging capacitors, burnt resistors, or any signs of overheating. Bingo! Two little guys near the primary side were looking a bit pregnant. These were the startup capacitors – crucial for providing the initial jolt to the main switching IC.I used a multimeter to check the suspect capacitors. Their capacitance was way below their rated value. They had grown weak and couldn't hold a charge properly, which explained why the PSU couldn't start reliably.I carefully desoldered the two bulging capacitors. I then soldered in two new, high-quality ones with the same (or slightly higher) voltage and capacitance ratings. No fancy tricks, just clean soldering work.I reassembled the unit, plugged it in from a safe distance (just kidding... mostly), and hit the power button. The lights blazed to life, and the fan spun up with a healthy whirr. Success!The patient made a full recovery! The PC has been running perfectly for months now, with no more shy behavior. It's now a brave, always-ready gaming beast.

Meu Conselho

Capacitors are the Usual Culprits: In older electronics, failing electrolytic capacitors are the cause of over 80% of failures. Always check them first. Quality Matters: Don't just replace a bad cap with an equally cheap one. Spend a little extra on reputable brands (like Nichicon, Panasonic) for a longer-lasting repair. If you see a fuse blown, DON'T just replace it. A blown fuse is a symptom. There's almost always a short circuit elsewhere that caused it to blow. Find and fix the root cause first.

Meu Problema

The copper electric kettle from BigElectronicStore stopped heating after 18 months; burnt-out element from limescale in Pakistan's hard water. Repairing the PKR 5,000 unit saved money over replacement.

Minha Solução

Unplugged, removed base screws, disconnected wires, descaled, swapped 1500W element (PKR 800 local part), reassembled in 45 mins per steps in referenced guides. Tested boil (1.7L in 4 mins), polished copper—no leaks

Meu Conselho

The repair sparked a real "aha" moment—like enlightenment in the kitchen chaos. Key takeaway: limescale from Pakistan's hard water kills elements fast, so descale monthly with vinegar (1:1 water mix, boil twice). ​ Pro tip for e-commerce sellers: Stock descaling kits as upsells with copper kettles; boosts reviews and repeat buys. Test post-repair by boiling vinegar—smell test confirms no residue. Future-proof by using filtered water daily

Meu Problema

My phone battery had started losing charge very quickly and the device was becoming difficult to use throughout the day. Instead of replacing the entire phone, I decided to try repairing it and extending its life.

Minha Solução

I followed the iFixit repair guide step by step and took my time during the process. The instructions helped me understand each stage, from opening the device safely to replacing the battery. The repair required patience, but the guide made the process much easier to follow.

Meu Conselho

My biggest lesson was that many devices can be repaired instead of replaced. Take your time, organize your screws and parts, and read the guide carefully before starting. A little patience can save money and reduce electronic waste.

Meu Problema

My MacBook's battery had been getting worse for a while barely lasting two hours unplugged "he 'Service Recommended' warning kept popping up. I'd been putting off doing anything about it because I assumed it'd mean either an expensive trip to a repair shop or buying a whole new laptop I didn't really need.

Minha Solução

I ordered a replacement battery for my [MacBook Pro 13-inch M1 from Tech Depot UK, which arrived next day. The battery replacement took me around 2 hours. The trickiest part was opening the back cover, so I watched three YouTube videos before attempting it. Thankfully, Tech Depot UK included the special pentalobe screwdriver I needed, so I didn't have to buy any extra tools. Removing the old battery and fitting the new one was straightforward. Closing the back cover was another tricky step, but with a bit of help from YouTube, I managed to get everything back together successfully. Since fitting it it's back to lasting a full day again no more random shutdowns Battery Health in System Settings reads 100% now and my macbook is just as new. So happy tp take this risk and saved my money and macbook.

Meu Conselho

I realized the problem wasn't my MacBook at all it was just the battery wearing out, like any battery does over time. I'd been assuming a struggling laptop meant it was time for a whole new machine, but the rest of the hardware was perfectly fine. Once I understood that batteries are a wear-and-tear part, not a sign the computer's dying, replacing it myself felt obvious rather than intimidating.